V250 NVR Rev IV
Simple. Scalable. Secure.
VIDEO MANAGEMENT |
GETTING STARTED | V250 Rev IV NVR
Quick Start Guide
Package Contents
Before You Begin
1. Connect all cameras to PoE Camera Switch with Cat5, Cat5e, or Cat6
networking cable. Depending on your V250 model, 8 or 16 PoE ports will be available.
2. Connect the Corporate LAN Port to your Site LAN.
3. Connect a monitor to either HDMI, DVI and / or VGA.
4. Connect your mouse and keyboard (included) to the rear PS/2 ports.
5. Connect power.
a. The V250 will automatically power on and boot into a Wizard which will
guide you through the configuration of your video recorder.
PART NAME FUNCTION
1 POWER Shows the Power On/Off Status
2 Tx/Rx Blinks to indicate network usage
3 ALARM Blinks to indicate the alarm I/O has been triggered
4 REC Blinks to inidcate data is being recorded to the HDD
5 USB USB 2.0 port
1
NVR
POWER CABLE
RACK MOUNT EARS
MOUSE
KEYBOARD
TERMINAL BLOCK (FOR ALARMS)
2 3 4 5
SPEC VALUE
Voltage 100V-240V, 6A, 50HZ-60HZ
Operating Environment Indoor Equipment Only
Operating Temperature 32 -113° F / 0 - 45° C
Humidity 20~90% RH
Operating Information
To Next Page
General