4 ANSI MEDIUM VOLTAGE METAL-CLAD DIGITAL SWITCHGEAR
—
Warranty and general information
Read the following hazard classifications
carefully, and fully inspect the equipment for any
identifiable hazards prior to installation,
operation or maintenance. The following
classifications listed below will appear
throughout this document or on labels located on
the equipment. These are standard symbols
defined by ANSI Z535.4-2011 which were
established for recognition of potential hazards
which pose risk to life and property. The
classification is based on the probability and
severity of injury if the hazard is not avoided.
Please follow instructions, warnings, labels and
codes for proper installation, operation, and
maintenance of equipment and devices. Only
Qualified Persons, as defined by NFPA 70, should
provide installation, operation, and maintenance
on this equipment and devices.
Danger symbol/Warning symbol
The addition of either symbol to a "Danger" or
"Warning" safety label indicates that an electrical
hazard exists that will result in personal injury if
the instructions are not followed.
This is the safety alert symbol. It is used to alert
you to potential physical injury hazards. Obey all
safety messages that follow this symbol to avoid
possible injury or death.
Danger: Indicates a hazardous situation which, if
not avoided, will result in death or serious injury.
Warning: Indicates a hazardous situation which, if
not avoided, could result in death or serious
injury.
Caution: Indicates that if the hazard is not
avoided, could result in minor or moderate injury.
Notice: Is used to notify of practices not related
to personal injury.
Trademarks
All rights to copyrights, registered trademarks
and trademarks reside with their respective
owners.
Warranty
This document is based on information available
at the time of publication. While efforts have
been made to ensure accuracy, the information
contained herein does not cover all details or
variations in hardware or software, nor does it
provide for every possible contingency in
connection with installation, operation, and
maintenance. Features may be described herein
that are not present in all hardware and software
systems.
ABB assumes no obligation of notice to holders of
this document with respect to changes
subsequently made. ABB makes no
representation or warranty, expressed, implied,
or statutory, with respect to, and assumes no
responsibility for the accuracy, completeness,
sufficiency, usefulness of the information
contained herein.
No warranties of merchantability or fitness for
purpose shall apply.
WARNING
CAUTION
DANGER
WARNING
CAUTION
NOTICE
SAFETY
INSTRUCTIONS
DANGER
WARNING
CAUTION
NOTICE
SAFETY
INSTRUCTIONS
To Next Page
Loading...
Need help?
General
