1
Safety instructions
WARNING! Obey the safety instructions. If you ignore them, injury or death, or damage to the
equipment can occur. See the user’s manual.
Mechanical installation
Electrical installation
Layout of the module
1
1. Pull out the lock.
2. Install the module carefully to an option module slot of
the drive. See the drive hardware manual.
3. Push in the lock.
4. Tighten the screw to torque 0.8 N·m using a Torx
TX10 screwdriver.
3
4
WARNING! Do not use excessive force, or leave the screw too loose. Over-tightening can damage
the screw or module. A loose screw decreases the EMC performance, and can even cause an
operation failure.
No. Description
1 Lock
2 Mounting and grounding screw
3 RJ-45 connector [X1] to Ethernet
4 Diagnostic LEDs
5MAC ID
—
OPTIONS FOR ABB DRIVES
FENA-01/-11 Ethernet adapter module
Quick installation and start-up guide
To Next Page
Need help?
General
