ABB M2M series Installation And Maintenance Instruction

Fläkt Woods 8265 GB 2011.10 2 Specifications are subject to alteration without notice
Installation and maintenance instruction
Fläkt Woods three phase asyncronous motor
Manufacturer: ABB
Use
Operating conditions
Themachinesareintendedforuseinindustrialdrive
applications.
Normalambienttemperaturelimitsare-25°Cto+40°C.
Maximumaltitude1000mabovesealevel.
Safety considerations
Themachineisintendedforinstallationandusedby
qualifiedpersonnel,familiarwithrelevantsafety
requirements.
Safetyequipmentnecessaryforthepreventionof
accidentsattheinstallationandoperatingsitemustbe
providedinaccordancewiththelocalregulations.
Points to observe
1.Donotusethemachinetostepon
2.Thetemperatureoftheoutercasingofthemachine
 maybehottothetouchduringnormaloperation.
3.Somespecialmachineapplicationsrequirespecial
 instructions(e.g.usingfrequencyconvertersupplies)
4.Liftinglugsmustonlybeusedforliftingthemotor.
 Theymustnotbeusedtoliftthemotorwhenitis
 attachedtootherequipment.

Handling
Operating conditions
Themachineshouldalwaysbestoredindoors,indry,
vibrationfreeanddustfreeconditions.
Unprotectedmachinedsurfaces(shaft-endsandflanges)
shouldprotectedwithanti-corrosivepaint.
Itisrecommendedthatshaftsberotatedperiodicallyby
handtopreventgreasemigration.
Anticondensationheaters,iffitted,shouldpreferablybe
energised.
Thecharacteristicsofelectrolyticcapacitors,iffittedto
single-phasemotors,willrequire“reforming”following
periodsofstorageexceeding1-2years.
ContactABBSalesOfficefordetails.
Transportation
Machinesfittedwithcylindrical-rollerand/orangular
contactbearingsmustbefittedwithlockingdevices
duringtransport.
Lifting
Onlyliftthemotorusingtheliftinglugs.
Thecenterofgravityofmotorswiththesameframemay
WARNING!
 Smallmotorswithsupplycurrent 
 directlyswitchedbythermallysensitive
 switchescanstartautomatically.
varyduetodifferentoutputs,mountingarrangementsand
auxiliaryequipment.
Checkthateyeboltsortheliftingeyesintegratedwiththe
motorframeareundamagedbeforelifting.Damaged
liftingeyesmustnotbeused.
Liftingeyeboltsmustbetightenedbeforelifting.Ifneeded
thepositionoftheeyeboltmustbeadjustedwithsuitable
washers.
Ensurethatproperliftingequipmentisusedandthatthe
sizesofthehooksaresuitablefortheliftinglugs.
Caremustbetakennottodamageauxiliaryequipmentand
cablesattachedtothemotor.directionofrotationisaccor-
dingtothearrowmarkedonthemachine.
Machine weights
Totalmachineweightcanvarywithinthesameframesize
(centerheight)dependingondifferentoutput,mounting
arrangementsandaddedfeatures.
Thefollowingtableshowsestimatedmaximumweights
formachinesintheirbasicversionsasafunctionofframe
material.
Onmachinesweightingmorethan25kg,theactualweight
isstatedontheratingplate.
Installation
Cooling
Normalambienttemperaturesshouldnotexceed40°C
(marinestandard50°C)ifstandardperformanceistobe
achieve.Checkthatthemotorhassufficientairflow.
Ensurethatnonearbyequipmentorsurfacesradiate
additionalheattothemotor.Formoreinformationabout
higherambienttemperaturesandcooling,see“theMotor
Guide”orcontactABBSalesOffice.
Aluminium Cast iron Steel
Frame
size
Weight
kg
Add.
for brake
Weight
kg
Weight
kg
63 6 - - -
71 8 5 13 -
80 12 8 20 -
90 17 10 30 -
100 25 16 40 -
112 36 20 50 -
132 63 30 90 -
160 110 55 175 -
180 160 65 250 -
200 220 - 310 -
225 295 - 400 -
250 370 - 550 -
280 - - 800 600
315 - - 1300 1000
355 - - 2300 2200
400 - - 3500 3000

ABB M2M series Specifications

General

Brand	ABB
Model	M2M series
Category	Engine
Language	English