Name: ABB RER615
Brand: ABB
Rating: 4 (1 reviews)

To Next Page

Relion

product family

Grid Automation

Recloser Protection and Control RER615

Modbus Point List Manual

Table of Contents7
Section 1 Introduction13
This Manual13
Intended Audience13
Product Documentation14
Product Documentation Set14
Document Revision History14
Related Documentation15
Symbols and Conventions15
Symbols15
Document Conventions15
Functions, Codes and Symbols16
Section 2 Modbus Data Mappings21
Overview21
Supported Functions in RER61521
Indications23
Common Data 124
LD0.FPHLPTOC1 Three-Phase Non-Directional Overcurrent Protection, Low Stage (1)24
LD0.PHHPTOC1 Phase Overcurrent Protection, High Stage (1)25
LD0.PHIPTOC1 Phase Overcurrent Protection, Instantaneous Stage (1)25
LD0.FDPHLPDOC1 Three-Phase Directional Overcurrent Protection, Low Stage (1)26
LD0.FPDHLPDOC2 Three-Phase Directional Overcurrent Protection, Low Stage (2)26
LD0.DPHHPDOC1 Three-Phase Directional Overcurrent Protection, High Stage (1)27
LD0.FEFLPTOC1 Non-Directional Earth-Fault Protection, Low Stage (1)27
LD0.EFHPTOC1 Non-Directional Earth-Fault Protection, High Stage (1)27
LD0.EFIPTOC1 Non-Directional Earth-Fault Protection, Instantaneous Stage (1)28
LD0.FDEFLPDEF1 Directional Earth-Fault Protection, Low Stage (1)28
LD0.FDEFLPDEF2 Directional Earth-Fault Protection, Low Stage (2)28
LD0.DEFHPDEF1 Directional Earth-Fault Protection, High Stage (1)29
LD0.INTRPTEF1 Intermittent Earth Fault Protection (1)29
LD0.EFPADM1 Admittance-Based Earth-Fault Protection (1)29
LD0.EFPADM2 Admittance-Based Earth-Fault Protection (2)29
LD0.EFPADM3 Admittance-Based Earth-Fault Protection (3)30
LD0.WPWDE1 Wattmetric-Based Earth-Fault Protection (1)30
LD0.WPWDE2 Wattmetric-Based Earth-Fault Protection (2)30
LD0.WPWDE3 Wattmetric-Based Earth-Fault Protection (3)30
LD0.HAEFPTOC1 Harmonics-Based Earth-Fault Protection (1)31
LD0.NSPTOC1 Negative-Sequence Overcurrent Protection (1)31
LD0.NSPTOC2 Negative-Sequence Overcurrent Protection (2)31
LD0.PDNSPTOC1 Phase Discontinuity Protection (1)32
LD0.ROVPTOV1 Residual Overvoltage Protection (1)32
LD0.ROVPTOV2 Residual Overvoltage Protection (2)32
LD0.PHPTUV1 Phase Undervoltage Protection (1)32
LD0.PHPTUV2 Phase Undervoltage Protection (2)33
LD0.PHPTUV3 Phase Undervoltage Protection (3)33
LD0.PHPTOV1 Phase Overvoltage Protection (1)34
LD0.PHPTOV2 Phase Overvoltage Protection (2)34
LD0.PHPTOV3 Phase Overvoltage Protection (3)34
LD0.PSPTUV1 Positive-Sequence Undervoltage Protection (1)35
LD0.NSPTOV1 Negative-Sequence Overvoltage Protection (1)35
LD0.FRPFRQ1 Frequency Protection (1)36
LD0.FRPFRQ2 Frequency Protection (2)36
LD0.T1PTTR1 Thermal Overload Protection (1)37
CTRL.CCBRBRF1 Circuit Breaker (1) Failure Protection37
LD0.INRPHAR1 Three-Phase Inrush Detection (1)37
LD0.TRPPTRC1 Protection Trip Conditioning (1)38
LD0.TRPPTRC2 Protection Trip Conditioning (2)38
LD0.MAPGAPC1 Multipurpose Analog Protection Function (1)38
LD0.MAPGAPC2 Multipurpose Analog Protection Function (2)39
LD0.MAPGAPC3 Multipurpose Analog Protection Function (3)39
LD0.MAPGAPC4 Multipurpose Analog Protection Function (4)39
LD0.MAPGAPC5 Multipurpose Analog Protection Function (5)40
LD0.MAPGAPC6 Multipurpose Analog Protection Function (6)40
LD0.CMHAI1 Current Total Demand Distortion (1)40
LD0.VMHAI1 Voltage Total Demand Distortion (1)40
LD0.PHQVVR1 PQ - Voltage Variation Signals (1)41
LD0.VSQVUB1 Voltage Unbalance (1)41
CTRL.CBXCBR1 Circuit Breaker (1) Blocking Signals41
CTRL.DCSXSWI1 Disconnector Position Indication (1)42
CTRL.DCSXSWI2 Disconnector Position Indication (2)42
CTRL.ESSXSWI1 Earthing Switch Indication (1)42
CTRL.ESSXSWI2 Earthing Switch Indication (2)42
LD0.DARREC1 AR State (1)43
LD0.DARREC1 Autorecloser (1)43
LD0.SECRSYN1 Synchrocheck (1)44
LD0.SSCBR1 Circuit Breaker (1) Condition Monitoring44
LD0.TCSSCBR1 Trip Circuit Supervision (1)45
LD0.TCSSCBR2 Trip Circuit Supervision (2)45
LD0.SEQRFUF1 Fuse Failure Protection (1)45
LD0.MDSOPT1 Generic Operation Time Supervision (1)46
LD0.PHSVPR1 Voltage Presence Supervision (1)46
LD0.CMMXU1 Phase Current Limit Supervision (1)47
LD0.RESCMMXU1 Residual Current Limit Supervision (1)47
LD0.VMMXU1 Phase Voltage Limit Supervision (1)47
LD0.VMMXU2 Phase Voltage Limit Supervision (2)48
LD0.MVGAPC1 Multipurpose Binary Inputs (1)48
LD0.MVGAPC2 Multipurpose Binary Inputs (2)49
LD0.SPCGGIO1 Multipurpose Binary Output States (1)49
LD0.SPCGGIO2 Multipurpose Binary Output States (2)50
LD0.SPCRGGIO1 Multipurpose Binary Output States (1)51
LD0.SPCLGGIO1 Multipurpose Binary Output States (1)52
LD0.GSEGGIO1 Goose Supervision (1)53
LD0.LEDPTRC1 Global Conditioning (1)53
LD0.LEDGGIO1 Indication LED States Off/Colorx53
LD0.LEDGGIO1 Indication LED States Color1/Color254
CTRL.CBCSWI1 Circuit Breaker (1) Mom. Position56
CTRL.CBCSWI1 Circuit Breaker (1) Mom+MCD Position56
CTRL.CBCILO1 Circuit Breaker (1) Enable Signals56
LD0.XGGIO130 Physical I/O States (BIO Card X130)56
LD0.XGGIO120 Physical I/O States (AIM Card X120)57
LD0.XGGIO110 Physical I/O States (BIO Card X110)57
LD0.XGGIO100 Physical I/O States (PSM Card X100)58
LD0.XAGGIO130 Physical I/O States (AIM Card XA130)59
Registers59
User Definable Registers [Alt.1], Visible on 3X and 4X59
User Definable Bits [Alt.2], Visible on 0X,1X,3X and 4X60
SSR1 System Status Register (1) Device Health60
SSR2 System Status Register (2) IED Mode and State61
SSR3 System Status Register (3) Data Available 1 (Client- Dependent)61
SSR4 System Status Register (4) Data Available 2 (Client- Dependent - User-Definable)62
SSR5 System Status Register (5) Device Alive Register62
SSR6 System Status Register (6) Control Command Status (Client-Dependent)63
LD0.T1PTTR1 Thermal Protection Values (1)63
LD0.CMHAI1 Current Total Demand Distortion (1)64
LD0.VMHAI1 Voltage Total Demand Distortion (1)64
LD0.PHQVVR1 Short Duration Voltage Variations (1)65
LD0.DARREC1 Autorecloser Values (1)65
LD0.DARREC1 Autorecloser Counters (1)66
LD0.SECRSYN1 Synchrocheck (1)66
LD0.SSCBR1 Circuit-Breaker Condition Monitoring Values (1)66
LD0.MDSOPT1 Generic Operation Time Supervision67
LD0.CMMXU1 Phase Current Measurements (1)67
LD0.CMSQI1 Sequence of Current Measurements (1)67
LD0.RESCMMXU1 Residual Current Measurement (1)67
LD0.VMMXU1 Voltage Measurements (1)68
LD0.VMMXU2 Voltage Measurements (2)68
LD0.VMSQI1 Sequence of Voltage Measurements (1)69
LD0.VSMSQI2 Sequence of Voltage Measurements (2)69
LD0.PEMMXU1 Three-Phase Power Measurements (1)69
LD0.FMMXU1 Frequency Measurement (1)70
Indication Bits Mirrored in Registers70
LD0.VMSTA1 Voltage Demand Values (1)70
LD0.VMSTA2 Voltage Demand Values (2)71
LD0.PEMSTA1 Power Measurement Demand Values (1)71
LD0.RESCMSTA1 Residual Current Demand Value (1)72
LD0.CMSTA1 Phase Current Demand Values (1)72
CTRL.CBCSWI1 Circuit Breaker Operation Counter (1)73
LD0.PEMMTR1 Three-Phase Energy Measurements (1)74
System Diagnostic Values74
Control Structure 175
Control Structure 275
Control Structure 375
Control Structure 475
Control Structure 576
Control Structure 676
Control Structure 776
Control Structure 876
Device ID String77
IED Real-Time Clock (in Local Time Mode) - Read and Write (Synchronize)77
IED Real-Time Clock (in UTC Time Mode) - Read and Write (Synchronize)77
Time and Reason for Latest IED Reset78
Active Parameter Setting Group - Read and Write78
Event Record Structure78
Fault Record Structure Header82
Fault Record Data83
Controls84
Reset, Acknowledge and Trigger Points (A)84
LD0.LPHD1 IED Warm Reset (1)85
CTRL.CBCSWI1 Circuit Breaker (1) Control85
LD0.SRGAPC1 Reset SRGAPC1 Generic Flip-Flops86
LD0.SRGAPC2 Reset SRGAPC2 Generic Flip-Flops86
LD0.SPCGGIO1 Multipurpose Binary Outputs (1)86
LD0.SPCGGIO2 Multipurpose Binary Outputs (2)87
LD0.SPCRGGIO1 Multipurpose Binary Outputs (1)88
Section 3 Glossary89

Brand	ABB
Model	RER615
Category	Relays
Language	English

ABB RER615 Modbus Point List Manual

Table of Contents

Other manuals for ABB RER615

Questions and Answers:

ABB RER615 Specifications

Related product manuals