Communication
Address check
Busfault reaction
Busaddress
Parameter lock
I/O Data Profile
DevNet baudrate
MODBUS RTU
Ethernet
Extended
Modbus RTU
MODBUS baudrate
MODBUS frame
MODBUS bus timeout
Ethernet
IP setting mode
IP address octet 1
IP address octet 2
IP address octet 3
IP address octet 4
Subnet mask octet 1
Subnet mask octet 2
Subnet mask octet 3
Subnet mask octet 4
Gateway octet 1
Gateway octet 2
Gateway octet 3
Gateway octet 4
Enable webserver
Extended
Retrofit
IO Modules
Missing module react.
1) Only shown if DX1xx is enabled
2) Only shown if VI1x is enabled
3) Only shown if AI1/2 is enabled
DX1xx enabled
DX1xx settings
DX1xx monitoring
DX1xx HW + SW version
VI15x enabled
VI15x settings
VI15x monitoring
VI15x HW + SW version
AI1 enabled
AM1 settings
AM1 monitoring
AM1 HW + SW version
AI2 enabled
AM2 settings
AM2 monitoring
AM2 HW + SW version
DX1xx DI delay
DX1xx AO type
DX1xx AO err reac.
Nominal line voltage
Nominal power factor
Power scale factor
AMx mode
AMx CH1 type
AMx CH1 err reac
AMx Tmax trip level
AMx Tmax warn level
AMx Tmax delay
AMx CH2 type
AMx CH2 err reac
AMx CH3 type
AMx CH3 err reac
Communication Parameters
Within this submenu all communication related parameters can be configured. The diagram below shows the organisation of the
different parameter masks in the menu tree. The parameters are described in details in the section:
"Parameters and Data Structures on a Fieldbus->Parameter Organisation->Communication Parameters".
IO Module Parameters
Within this submenu all IO module related parameters can be configured.
The diagram below shows the organisation of the different parameter masks in the menu tree.
The parameters are described in details in the section
"Parameters and Data Structures on a Fieldbus->Parameter Organisation->IO Module Parameters".
106
To Next Page
Loading...
Need help?
General
