ABB
5:6
Approvals:
Control of:
Entire safety system based on
the dynamic safety circuit.
Features:
Easy installation
Flexible
Cost effective
Display for troubleshooting
(Vital 2 and 3)
A wide range of safety sen-
sors can be connected into the
circuit
Several safe outputs
Information output
Outputs with time delay
(Vital 2 and 3)
TÜV Nord – Vital 1
TÜV Rheinland – Vital 2 and 3
Vital is based on a single channel safety concept where multi-
ple safety sensors can be connected in series and monitored
with a single safety controller. A dynamic signal is sent from
Vital through all connected sensors, and then returned to Vital
which then evaluates the received signal. As each safety sen-
sor inverts the signal, it is possible to detect short circuits or
faults in any of the sensors. Vital 2 and Vital 3 are designed
for use with ABB Jokab Eden sensors, Tina components and
Spot light grids or similar products. Vital 2 and 3 are both
safety controllers with two safe input functions and two output
groups, the only difference between the two models being in
the input configuration.
Vital
Safety controller
To Next Page
Need help?
General
