Removing the Lancet
To remove the lancet,
pull off the cap of the
ACCU-CHEK Softclix
device.
Slide the ejector forward.
The lancet will release.
To avoid infection, use a new lancet each time you
perform a fingerstick. Dispose of the lancet in a puncture-
proof container with a lid, such as an empty coffee can.
Helpful Tip to Performing a Fingerstick
The best place to prick the fingertip is on the side
because it has the best blood supply, yet allows for the
least painful fingerstick. Any finger may be used for a
fingerstick.
Firmly insert a new ACCU-CHEK Softclix lancet in the
lancet holder until it snaps into place.
Twist the protective cap
on the lancet several
times and pull gently to
remove it.
Put the cap back onto the
lancet device. The cap only
fits when the notch on the
cap is aligned with the
center of the semi-circular
cutout on the ejector.
Select the desired depth of penetration by turning the
Comfort Dial so that the center of the semi-circular cutout
on the ejector points to the appropriate number or dot. The
higher the number, the greater the depth of penetration.
Then, press the plunger on the end of the device all the
way down, and you will hear a “click.” When the device is
ready, you will see a yellow dot appear and remain in the
center of the clear release button.
Now, wash your hands in warm soapy water and warm
the fingers to increase blood flow. If you are using alcohol
wipes, make sure your finger is completely dry before
continuing.
Grasp your finger near the area to be pricked and gently
massage for three seconds.
Keeping your hand down,
press the tip of the
ACCU-CHEK Softclix device
firmly against the side of
your fingertip. Press the
release button to stick
your fingertip, then gently
squeeze until you get a
small sample of blood.
Apply the drop to the test strip you are using.
I
mmediately remove used lancet. To avoid accidental
injury, do not store lancet in device.
To Next Page
Loading...
Need help?
General
