10
English
Getting started watching your TV
1
Power
Press the power button on the remote control or TV set.
2
Installation Guide
The first time you switch on the TV, you will be asked to select the language and
scan for channels.
Press the OK key to begin the setup process.
Step 1. Select the setup language you prefer.
You can also adjust these settings using the side control panel. Please see "Front
and side panels" on page 5 for details.
Step 2. Please select the correct country for signal reception.
Step 3. Select the correct the tuner mode.
Step 4. Ensure that your co-axial cables are connected correctly before proceeding.
Step 5. Scan for digital channels and analog channels.
Step 6. Select Home mode.
Step 7. Setup is now complete. You are ready to begin watching TV.
3
Changing channels
a. Press 0 - 9 on the remote control to select a channel. The channel changes after
2 seconds. Press OK to select the channel immediately.
b. Pressing the channel (CH) up / down button on the remote control will also
change the channel.
4
Adjusting the volume
Adjust the volume level using the (VOL) up/down button on the remote control.
Setup may vary due to local broadcast differences.
To Next Page
Loading...
Need help?
General
