WZ14:4:2 USER GUIDE 19
OPTIONS
The Mix Wizard Series WZ14:4:2 has a versatile architecture designed to satisfy your live
sound and recording requirements without modification. The following internal options are
offered to provide alternative settings for those applications which may demand them.
These options require resoldering of circuit board links and should only be carried out by
competent technical personnel. Further information is available from your service agent or
the WZ14:4:2 SERVICE MANUAL.
CHANNEL PRE-FADE AUX SEND OPTIONS
The Pre-fade aux sends are set post-EQ and post-ON as standard. However, link options
on each mic/line channel 1-10 and stereo channels 11-12 and 13-14 circuit board
assemblies allow pre-EQ and/or pre-ON if required.
STEREO CHANNEL AUX SENDS
The stereo input channels allow stereo input signals to feed the auxiliaries as stereo pairs.
By removing a link the left input signal will feed AUX 1, 3, 5, and the right input signal will
feed AUX 2, 4, 6.
CHANNEL DIRECT OUTPUT SOURCE
The direct outputs are sourced post-fader as standard. A link option is available on each
channel assembly to select a pre-fade source.
SYS-LINK
TM
OPTION
The SYS-LINK
TM
option is an internally fitted circuit board and wiring harness which can
easily be installed by your service agent. The SYS-LINK
TM
option allows up to five ALLEN &
HEATH consoles to be electronically connected together via a 25 pin D type multiway
interconnecting cable to provide more inputs to the mix.
RIAA OPTION
An RIAA PCB assembly plus earth post can be fitted to input A of each of the two stereo
input channels to allow connection for a turntable. Contact your dealer or service agent.
To Next Page
Loading...
Need help?
General
