Xone:23CQuickStartGuide—Issue1 6 ALLEN&HEATH
DVS Setup
XONE:23C and the Cross LE A&H Edition can also be used with MIXVIBES timecode vinyl.
An internal modification is required to reconfigure the mixer’s soundcard routing.
see p19 of the XONE:23C User Guide for details.
Open the Preferences dialogue
Click on Vinyl/CD
Activate Control Deck 1
Activate Control Deck 2
Click on the Input: drop-down menus
Select Input 1/Input 2 for Deck 1
Select Input 3/Input 4 for Deck 2
Click the Control Media: drop-down
Select MV Vinyl
Click the Calibrate buttons.
If you use turntables, Cross LE automatically sets the input gain level to an appropriate gain level for optimizing the decoding
quality. If you use timecode CDs you may need to reduce the gain manually
Close the Preferences window
Enable Control Decks
Hover over the top right of the waveform view to display Control Deck options.
To control Player A from timecode source connected to Input 1*
click Use Control Deck 1
To control Player B from a timecode source connected to Input 3*
click Use Control Deck 2
*If you use timecode to control audio, or set the Cross LE Players for LINE IN
Check the INPUT level for the corresponding XONE:23C channel (1 or 3) is set at minimum.
This is important to ensure the signal only routes to the MIX via soundcard channel outputs.
To Previous Page
Loading...
Need help?
General
