EasyManuals Logo
Home>AMX>Recording Equipment>DAS-T0804-SIG

AMX DAS-T0804-SIG Specifications

AMX DAS-T0804-SIG
2 pages
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #2 background imageLoading...
Page #2 background image
DAS-T0804-SIG / DAS-T0808-SIG DATA SHEET
3000 RESEARCH DRIVE, RICHARDSON, TX 75082 • 800.222.0193 • 469.624.8000 • +1.469.624.7400 • 469.624.7153 fax • www.amx.com
Technical Drawing Forthcoming
DAS-T0804-SIG (FG1103-01)
DAS-T0808-SIG (FG1103-02)
POWER
960W max (actual average usage = 300W)
DIMENSIONS (HWD)
4” x 17” x 13 1/2” (including feet) (10.2 cm x 43.2 cm x 34.3 cm)
WEIGHT
31 lbs (14.06 kg)
FRONT PANEL COMPONENTS
Navigation Buttons allow for front panel programming, selection of
sources, and tuning AM/FM radio stations (when controller is fitted with
the optional tuner board). The same array appears on the Matrix KP-4e
navigational keypad
IR Receiver - Where you must aim the remotes from your audio source
components so the Controller can learn and emulate those commands
LCD Display - Displays information necessary during the programming
steps and afterward is the display to indicate information about the source
input and zone activity
REAR PANEL COMPONENTS
Power Switch & Receptacle - The master power switch will remain in the
ON position normally
Paging In/Out Ports - RCA jacks to connect to paging devices (any audio
input can be used as a paging device). The paging device connects to the
Controller via the “paging in” connector. The “paging out” connector is
used to carry the page to zone expander(s)
RJ 45 Port - Ethernet Port for future expansion
RS-232 Port 9-pin D connector to interface with NetLinx control systems
AM/FM Antenna Inputs - Connections for the AM and FM Antennas
Audio Inputs - Stereo Inputs, 47K impedance, buffered
Audio Outputs - Stereo looping outputs, buffered
IR Outputs - Eight IR 3.5mm mono output jacks
Zone Outputs - Connections for up to 8 zone outputs that connect to
the keypads
Expansion Port - RJ 11 port connects main Controller with zone expanders
STEREO OUTPUT
40 Watts/CH stereo (20Hz to 20Khz @ .1% THD)
ZONE SUPPORT
Four (DAS-T0804-SIG) or eight (DAS-T0808-SIG) independent zones
Each zone is protected thermally
Zone grouping
Independent volume, bass, treble, balance and SRS® controls in each zone
STEREO AMPLIFIERS
40 Watts/CH stereo amplifiers (20Hz to 20Khz @ .1% THD)
Amplifiers are protected from overload and thermal runaway
SRS/WOW®
Standard SRS/WOW® audio enhancement technology by SRS Labs, on
all zones
(Note: SRS/WOW is a registered trademark of SRS labs, inc.)
PRELIMINARY SPECS - SUBJECT TO CHANGE

Other manuals for AMX DAS-T0804-SIG

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the AMX DAS-T0804-SIG and is the answer not in the manual?

AMX DAS-T0804-SIG Specifications

General IconGeneral
BrandAMX
ModelDAS-T0804-SIG
CategoryRecording Equipment
LanguageEnglish

Related product manuals