REV APPR
written permission.
shall be confidential except
NOTICE: This drawing is the
property of AMX Corporation.
that is not generally known
to the extent the information
has been previously established.
This drawing may not be copied,
for manufacture or sale without
reproduced, or used as the basis
All information contained herein
PROJECTION
MATL SUP
QUALITY
DRAWN
ENGR SERV
PROD ENGR
ENGINEER
THIRD ANGLE
REL APPR REL DATE
PICTORIAL,
PS4.4 POWER SUPPLY
13.5VDC 4.4A, SHOWN USING A
BARREL PLUG
95-0423-44
95-0423-44-B
B
FULL
1 OF 1
SHEET
DWG. NO.
SCALE
SIZE
B
TM
REV.
A
5492 RELEASE TO PRODUCTION
10/21/03
REV ECN APPROVED
REVISIONS
DESCRIPTION DATE
All information contained herein
reproduced, or used as the basis
for manufacture or sale without
This drawing may not be copied,
has been previously established.
to the extent the information
that is not generally known
property of AMX Corporation.
NOTICE: This drawing is the
shall be confidential except
written permission.
TOLERANCE ON DECIMAL DIMENSIONS: XX = .010
SURFACE FLATNESS .003 TIR PER LINEAR INCH.
FRACTIONAL DIMENSIONS INCLUDING HOLES: +/- 1/64
DO NOT SCALE THIS DRAWING.
TOLERANCE ON HOLE DIAMETERS:
OVER .500
.250 TO .500
UNDER .250 ú
ALL DIMENSIONS IN INCHES.
ANGLES: +/- 1.0°
= +.008 -.005
= +.006 -.005
XXX = .005
= +/- .005
UNLESS OTHERWISE SPECIFIED:
DAS 10/16/03
DB 10/21/03
RDR 10/21/03
KZ 10/21/03
MD 10/21/03
AK 10/21/03
B
5566
REMOVE NOTE
11/4/03
DB
PL
KZ
KL
AK
Need help?
General
