ANCHOR Audio, Inc. (310) 784-2300
100-0026-000 / Revision D, 06/97
Owner’s Manual
AN-1000X
Having trouble with the sound system?
Condition Possible Solution
No sound (power LED not lit): • turn POWER switch on
• plug in power cord
• check for blown fuse
No sound (power LED lights): • check for output from source
• make sure all cables are completely plugged in
• increase volume control
Distorted sound: • check input cable connection
• lower input signal level
Excessive hum or noise: • use shielded input cable
Mic volume too low: • set balanced input to mic-level
Blows fuse with auxiliary speaker: • shorted speaker cable
Troubleshooting Guide