Andersen A Series User Manual

3
0005413
1
Hinge and Hardware Adjustments
Panel Horizontal Adjustment (Side to Side)
2
Panel Vertical Adjustment (Up and Down)
• Check for equal gap between panel and frame at top and bottom.
• Starting with the bottom hinge, turn vertical adjustment screw
clockwise (+) 1/2 turn and then continue turning until panel is
centered vertically in frame.
• Turn next hinge vertical adjustment screw clockwise (+) until panel
moves slightly, then turn counterclockwise (−) 1/4" turn. Repeat for
remaining hinges working upward.
• Check for equal gap between panel and frame along both sides.
• Starting with the bottom hinge, turn horizontal adjustment screw as shown
to adjust panel as needed. Repeat for remaining hinges working upward.
• Check that gap between panel and frame on latch side and hinge side is
equal to the thickness of the 5/32" hex key.
Turn counterclockwise
(IN) to move panel
toward hinge side jamb.
Turn counterclockwise
toward (−)
to lower panel
Turn clockwise
toward (+)
to raise panel
Turn clockwise (OUT)
to move panel away
from hinge side jamb.
Move all
hinges IN or
OUT to correct
gap and
center panel
in frame.
5/32"
Hex Key
5/32"
Hex Key
Horizontal
Adjustment
Screw
Vertical
Adjustment
Screw
Bottom
View
During counterclockwise rotation, stop adjustment
when adjustment screw hits the back side of the cover
and resistance increases. Failure to do so could cause
product damage.
NOTICE
Equal gap
along top
and bottom
Equal gap
along both
sides

Andersen A Series Specifications

General

Brand	Andersen
Model	A Series
Category	Indoor Furnishing
Language	English