What to do if my Argo Offroad Vehicle engine doesn’t turn over?
If your Argo Offroad Vehicle's engine doesn't turn over, possible causes include a tripped circuit breaker (reset the breaker), low battery voltage (recharge the battery to 12.5 VDC), or loose connections at the battery or solenoid (check all connections and the ignition).
What to do if Argo Offroad Vehicle engine turns over but doesn't start?
If your Argo Offroad Vehicle engine turns over but fails to start, it could be due to several reasons: * The vehicle is out of fuel: Refuel. * The fuel filter is clogged: Inspect and clean or replace it. * There is water in the fuel: Drain the fuel system and refuel. * The spark plug is fouled or defective: Inspect the plug and replace if necessary. * Low battery voltage: Recharge the battery to 12.5 VDC. For issues like a crankcase filled with water or fuel, or mechanical failure, it's best to see your dealer.
Why does my Argo Offroad Vehicle engine stop or lose power?
If your Argo Offroad Vehicle engine stops or loses power, there are several potential causes. You might be out of fuel (refuel), have a kinked or plugged fuel vent line (inspect and replace), or have water in the fuel (replace with new fuel). Other possible causes include fouled or defective spark plugs (inspect, clean and/or replace spark plugs), loose ignition connections (check all connections and tighten), low battery voltage (recharge battery to 12.5 VDC), incorrect fuel (replace with recommended fuel), or a clogged air filter (inspect and clean or replace). For worn or defective spark plug wires, reverse speed limiter malfunction, electronic throttle control malfunction, other mechanical failure, or an overheated engine, it is recommended to see your dealer.
Why does my Argo Offroad Vehicle engine backfire?
If your Argo Offroad Vehicle engine backfires, possible causes include weak spark from spark plugs (inspect, clean and/or replace spark plugs), incorrect spark plug gap or heat range (set gap to specs or replace plugs), or old or non-recommended fuel (replace with new fuel). For issues like incorrectly installed spark plug wires, incorrect ignition timing, or mechanical failure, it is recommended to see your dealer.
Why does my Argo Offroad Vehicle engine run irregularly, stall, or misfire?
If your Argo Offroad Vehicle engine runs irregularly, stalls, or misfires, it could be due to fouled or defective spark plugs (inspect, clean and/or replace spark plugs) or incorrect spark plug gap or heat range (set gap to specs or replace plugs). If the spark plug wires are worn or defective, it is recommended to see your dealer.
General| Brand | Argo |
|---|---|
| Model | Explorer XRT 1000 LE |
| Category | Offroad Vehicle |
| Language | English |
Key safety instructions for ATV operation and age recommendations.
Importance of reading and understanding labels; do not remove them.
Details on specific warning labels regarding hills, reverse operation, and override.
Warnings about speed limits, gear indicators, and operator age.
ATV handling differs; collision/rollover risk. Emphasizes training.
Age restrictions for operation and need for adult supervision.
Avoid streets, use proper gear, no alcohol/drugs, control speed.
Advice on hills, slippery terrain, water, and load capacity.
Warnings against stunts, improper modifications, and securing cargo.
Danger of carbon monoxide from engine exhaust; do not run engine indoors.
Failures to inspect increase accident risk; do not operate if problems found.
List of items to check before using the vehicle (fuel, oil, brakes, tires, etc.).
Checks for brake pedal/levers, axle boots, chassis fasteners, and instruments.
How to use the four-wheel brake lever and brake pedal, and important checks.
Explanation of shift lever positions (L, H, N, R, P) and shifting instructions.
How to use the button to change between 2WD, 4WD, and LOCK modes.
Details on 2WD, 4WD, and LOCK modes and their applications.
General riding instructions, emphasis on reading manual and understanding controls.
Importance of training, especially for inexperienced operators.
Age recommendation (under 16) and prohibition of passengers.
Warnings about operating without eye protection and consuming alcohol or drugs.
Warnings against stunts (wheelies, jumps) and improper modifications.
Hazards related to the hot exhaust system and combustible materials.
Preventing fire hazards from the exhaust system and avoiding burns.
Warnings about paved surfaces and riding on public roads.
Hazards of hidden rocks/bumps, rough terrain, and visibility issues.
Precautions for climbing hills safely.
Techniques for climbing hills safely, including weight shift and gear selection.
Handling rolling backwards, dismounting, and specific warnings for 2WD/4WD.
Procedures for descending hills safely.
Techniques for descending hills safely, including weight shift and gear selection.
Braking in 4WD, avoiding sharp angles, and choosing path.
Importance of periodic maintenance for safety and performance. Includes warnings.
General guide for maintenance intervals based on time and mileage.
Specific maintenance items, intervals (initial/every), and required actions.
Possible causes and solutions for engine not turning over.
Possible causes and solutions for engine failing to start.
Possible causes and solutions for engine pings or knocks.
Possible causes and solutions for engine backfires.
Possible causes and solutions for engine stalling or losing power.
To Next Page