4. Fit the outside handle (with keypad) on
the door. Make sure to keep the handle
horizontal during when fixing.
5. Connect the inner- and outer handle
with the screws. Be sure to fit the handle
correctly, so that both handles rotate back
without any problems.
The handle fit door thickness of 35-80 mm
with a B-measurement (see image 5) of at
least 21 mm. For smaller B-measurement
down to 14 mm, use distance ring 8820.
6.
1. Add at least one user code, see instruc-
tions on the opposite side.
2. Unlock the handle by keying the correct
code using the keys 1-4.
If the wrong code is used the light will alter
between red and green. (The handle will
remain open when the correct code is used
provided that auto locking mode has not
been selected, see opposite side).
7. Lock the handle by pressing the padlock
key.
ASSA ABLOY
Code Handle
Fitting- and operating
instruction
ASSA ABLOY, the global leader
in door opening solutions.
Fitting instruction
Before fitting
Before fitting the handle to the door, it has
to be initiated with an administration code.
The handle has no administration code
when delivered.
1. Keep the handle horizontal with the
spindle pointing down.
2. Press button 1 and 4 at the same time.
The led will flash red.
3. Stop pressing the buttons. The green
light will stay on constantly.
4. Enter a 6 digit administration code. The
light will flash green rapidly. The admi-
nistration code is valid.
To change administration code, repeat
the notes above. N.B. that all user codes
will disappear when you change adminis-
tration code.
2. Turn the spindle so that the track will
point upwards, as shown on the picture.
Keep this position when fitting, according
to picture 4.
3. Place the inner handle on the door and
fit the enclosed screws through the door
blade. Cut the screws in the nearest waist
on the screw, max 6 mm outside the door-
blade. A 22 mm (minimum) hole through
the door is needed to accommodate for the
cam around the spindle.
To Next Page
Need help?
General
