• If the steps above do not help, remove the onboard battery and move the jumper again
to clear the CMOS RTC RAM data. After clearing the CMOS, reinstall the battery.
• You do not need to clear the RTC when the system hangs due to overclocking. For
system failure due to overclocking, use the C.P.R. (CPU Parameter Recall) feature.
Shut down and reboot the system so the BIOS can automatically reset parameter
settings to default values.
1. Turbo Key II switch
This switch allows you to auto-tune your CPU to enhance the system performance.
• The
O2LED2
LED near the Turbo Key II switch lights when the switch setting is turned
to
Enable
. Refer to section
2.9 Onboard LEDs
for the exact location of the
O2LED2
LED.
• If you clear the CMOS or load the BIOS setup defaults, the related overclocking items
in the BIOS menu follow the current setting of the Turbo Key II switch.
• If you change the switch setting to
Enable
under the OS environment, the Turbo Key II
function will be activated after the next system bootup.
• You may use the TurboV Auto Tuning, overclock in the BIOS setup program, and
enable the Turbo Key II function at the same time. However, the system will use the
last setting you have made.
For ensuring the system performance, turn the switch setting to
Enable
when the system is
powered off.
To Next Page
Loading...
Need help?
General
