Contents
1 Hardware
Specifications
1.1 RT-AC56S♦
•
2 Flashing DD-WRT
Firmware
•
3 Reset•
4 Recovery Mode
Flashing
4.1 OEM
Firmware
Installation
♦
•
5 VLAN Configuration•
6 Overclocking•
Hardware Specifications
FCC ID: MSQ-RTAC56U (or MSQ-RTAC56UA)
CPU: Broadcom BCM4708A0 (800 MHz, 2 cores)•
Flash / RAM: 128 MiB / 256 MiB•
WAN: 1 port, 10/100/1000•
LAN: 4 ports, 10/100/1000•
USB: 2 ports, USB 3.0, USB 2.0•
WI1: Broadcom BCM4352, an+ac
MIMO config: 2x2:21.
Antenna connector: none2.
•
WI2: Broadcom BCM43217, bgn
MIMO config: 2x2:21.
Antenna connector: none2.
•
ETH chip1: Broadcom BCM4708A0•
Switch: Broadcom BCM4708A0•
Power Supply: 19V (DC) @ max 1.75A•
RT-AC56S
This uses the single-core CPU variant (BCM47081A0), has 128 MiB RAM, and different power supply.
There is no evidence that it is supported at all, despite the FCC ID being listed as MSQ-RTAC56UA (CPU in
the Internal Photos is BCM4708A0). Do not try AC56U firmware on an AC56S unless willing to brick.
AsusWRT-Merlin might work on the AC56S with AC56U firmware, but no official support is mentioned.
Flashing DD-WRT Firmware
Brainslayer builds for ARM Broadcom routers have their own directory. Do not use the /broadcom*/
directories. Example: asus_rt-ac56u-firmware.trx tested here but this isn't a recommendation. New build links:
Asus_RT-AC56U
Flashing DD-WRT Firmware 1