RT-BE96U
BE19000 Tri-band WiFi Router
Quick
Start Guide
Hardware Explanations
Gain Another 10GE LAN Port
DC Power adapter DC Output: +19V with max 3.42A current
DC Output: +19.5V with max 3.33A current
Operating Temperature 0~40
o
C Storage 0~70
o
C
Operating Humidity 50~90% Storage 20~90%
Specications:
Router Setup Steps
Prepare your Modem
01
1
Unplug the power of cable / DSL modem.
5
[App] Launch ASUS Router App and follow
the instructions to complete the setup.
Modem back
Install your Router
02
1
Plug the adapter into the DCIN port,
and press the Power switch.
2
Connect your modem to the WAN port at the back side of the router with the
network cable provided.
3
Power on the modem. Plug
modem to the power outlet and
power on.
Modem back
4
Check the modem LED lights to ensure the connection is active.
If you are using DSL for internet,
you will need your username /
password from your Internet
service provider (ISP) to properly
configure your router.
Modem front
– Or via web browser
3
[Wired] Connect your PC to a LAN (LAN2~4) port
at the back side of the router using an additional
network cable.
[Wireless] Connect to the network with default SSID
shown on the product label on the back side of your
router “ASUS_XX”.
4
[Wired / Wireless] Open a web browser.
You will be redirected to the ASUS Setup Wizard. If not, navigate to
http://www.asusrouter.com
Follow the instructions to
complete the setup.
http://www.asusrouter.com
– Via app
3
[App] On your iOS or Android mobile device, go
to the app store, search forASUS Router, and
download the app.
4
[App] On your iOS or Android mobile device, tapSettings > Wi-Fi,
connect to the default network SSID shown on the product label on
the back side of the router. Or scan the QR code on the product label
to connect the default network SSID.
* XX refers to the last two
digits of 2.4GHz MAC
address. You can find it
on the label on the back
of your router.
_
2
The Power LED will light up when the hardware is ready.
Power switch
LAN2-4 ports
Power (DCIN) port
Reset button
10GE LAN port
10GE WAN/LAN1 port
WPS button
* If no 6GHz SSID is displayed, please check whether your OS and client device are fully licensed to support the newly
released 6GHz band. You can check with your OS and client device provider for Wi-Fi 6E driver release schedule.
USB 3.0 port
USB 2.0 port
LED button
Connect to the 1GE WAN port
Connect the modem to the 1GE WAN port with a network
cable.
Login and Connect
1
[ASUS Setup Wizard] Select “Manual Setting”.
2
[ASUS Setup Wizard] Select “1G WAN”, then follow the instructions
to
complete the setup of SSID and login information.
Set up 1GE WAN connection to release another 10GE LAN Port
01
– Under factory defaults
10GE LAN LED
1GE LAN LED
10 /1GE WAN
(Internet) LED
WPS LED
Power LED
6GHz/5GHz/2.4GHz WiFi LEDs
1GE WAN/LAN1 port
To Next Page
Need help?
General
Weight and Dimensions
