A shaft extender kit (Model SE-8) is available to convert the screwdriver
adjustments to fingertip control. This is a user installed option which requires
removal of the front panel (4 screws), removal of the original screwdriver adjust
shafts by pinching the rear of the shaft and pulling it out of the pot, replacement
of the original shafts with the new ones and finally replacement of the panel (3
screws are enough, forget the one you dropped on the floor). In case you think
that we are giving you the shaft, forget it, these aren't free. Call Mr. Rockefeller in
our Parts and Accessories Department to order.
Output stage gains are set to +6dB, +16dB or +26dB by moving jumper
plugs P1, P2, P3 or P4 from their center position to the +10dB position on the
right or to the +20dB position on the left.
To Next Page
Loading...
Need help?
General