10
Pionjär 120/120AV 130/130AV
© 2005 Atlas Copco Construction Tools AB
|
No 9800 0438 51
|
2005-10-31
Safety and operating instructions
Additional safety instructions
Machines and accessories must only be used
for their intended purpose.
Only qualified and trained persons may operate
or maintain the machine.
Keep your hand away from the start and stop
device until work is to begin.
Learn how the machine is switched off in the
event of an emergency.
The machine should be operated at reduced
power when drilling is started.
Release the start and stop device in the case of
an interruption of the power supply.
Always inspect the equipment prior to use.
Do not use equipment if you suspect that it
could be damaged.
Check the tools for wear and damage at regular
intervals. Do not use worn out or damaged tools.
Always use your common sense and good
judgment.
Do not use the machine when you are tired or
under the influence of drugs, alcohol or anything
else that may affect your vision, reactions or
judgment.
Participate in safety and training courses.
Never strike or abuse any equipment.
Keep the machine and tools in a safe and locked
place out of the reach of children.
Make sure that the all attached and related
equipment is properly maintained.
Signs and decals that are important for your
safety and the care of the machine are included
with every machine. New signs and decals can
be ordered using the spare parts list.
Ź
Ź
Ź
Ź
Ź
Ź
Ź
Ź
Ź
Ź
Ź
Ź
Ź
Ź
Ź
Protective equipment
Always use approved personal protective
equipment. Operators and other persons in the
work area must wear protective equipment,
including at least:
Protective helmet
Hearing protection
Impact resistant eye protection with side
protection
Respiratory protection when appropriate
Protective gloves
Protective boots
Service and maintenance
Regular maintenance is a prerequisite for ensuring
that the machine is safe to use. Follow the
operating instructions carefully.
Use only authorized parts. Any damage or
malfunction caused by the use of unauthorized
parts is not covered by the Warranty or by
Product Liability.
Change damaged parts immediately.
Replace damaged and worn out components in
good time.
For a major service to the machine, contact your
nearest authorized Atlas Copco workshop.
When cleaning mechanical parts with solvent,
ensure that you comply with current health and
safety regulations are complied and that the
ventilation is satisfactory.
Machine tools
Keep the tools clean and in a good condition.
Check the tools regularly and make sure that
they are sharp.
Ź
Ź
Ź
Ź
Ź
Ź
Ź
Ź
Ź
Ź
Ź
Ź
Crowder Supply Co., Inc. • 8495 Roslyn St., Commerce City, CO 80022 • Toll Free: 888-883-5144 • www.CrowderSupply.com
www.CrowderSupply.com • Toll Free: 888-883-5144
To Next Page
Loading...
Need help?
General
