EN Power Focus 600
18
© Atlas Copco Industrial Technique AB - 9836 4954 01
Export/Import from a PC
When using this function from a PC the user will be prompted to select where
to save or get the exported file.
Export/Import from the controller
When using this function from the controller a USB-device must be connected
to be able to export and import data.
Motor tuning
Tool > Motor tuning
A motor tuning adjusts the tool’s motor control unit to optimize the perfor-
mance and minimize loss. A motor tuning should be performed on each specific
combination of controller and tool together.
{ , : profile5 in element [p]}Why and how often? What exactly does the motor
tuning do?
Starting the motor tuning
Before performing the motor tuning make sure tool and controller are set up to
perform tightenings.
Note! The motor tuning takes approximately 30 seconds and
rotates the spindle in both clockwise and counter-
clockwise direction before it is finished.
1. On the Tool menu, go to Motor tuning, and then
select Perform.
2. Press OK to start the Motor tuning.
• If the motor tuning was successful an OK
event will be displayed.
• If the motor tuning was not successful, or the
tool trigger was released before the motor tun-
ing was finished, a NOK event will be dis-
played.
Calibration
Tool > Calibration
Tool calibration is used to control how well a tool corresponds to a reference
transducer.
The calibration value stored in the tool memory is used to adjust the torque
value given by the tool’s torque transducer so that the correct torque value is
displayed on the controller. The controller displays the date when the tool was
last calibrated.
Preparing the calibration
{ , : noprofile in element [subsection]}
Make sure tool and controller are set up to perform tightenings. Set up the tool
with a torque reference transducer such as an ACTA or BLM Bench. Please re-
fer to the torque reference transducer’s user guide for setup instructions.
To Next Page
Loading...
Need help?
General
