STEP 1
Remove M1000 from package via hangers provided.
Hangers are factory installed to facilitate mounting of
the M1000 for upward sound dispersion, Figure 1.
This dispersion configuration is the most popular
and most effective.
If horizontal (side firing) dispersion is required, the
hangers may be re-located as shown in Figure 2.
If down firing dispersion is required, the hangers may
be relocated as shown in Figure 3.
STEP 2
Install the M1000 per Figure 1, 2 or 3, using hanger wire
(not included).
NOTE: Code requirements in many areas require the use of #12 suspension cable for
commercial applications. Check your local codes before installing the M1000.
STEP 3
Terminate service loop to the to the amplifier output line
(black is negative, red is positive) – see Figure 4.
NOTE: Strain relief is not designed to accommodate conduit. Use approved terminations
through the knock-outs provided on the M1000 cover plate when conduit is used.
STEP 4
Set tap selector switch to desired power setting.
M1000 WIRING BLOCK DIAGRAM
Specifications are subject to change without notice
AtlasSound.com
1601 JACK MCKAY BOULEVARD ENNIS, TEXAS 75119 U.S.A. • TELEPHONE: (800) 876-3333 • FAX: (800) 765-3435
©2002 ATLAS SOUND LP Printed in U.S.A. 001102 ATS001449 RevB 11/02 PP
INSTALLATION INSTRUCTIONS
M1000
WIRING DIAGRAM AND HOOK-UP
Figure 3
M1000 Shown w/hangers
configured for Downward
sound dispersion
Figure 1
M1000 Shown w/hangers
located as configured
from factory for Upward
sound dispersion
Figure 2
M1000 Shown w/hangers
configured for Horizontal
sound dispersion
Figure 4
SPECIFICATIONS
MAGNET SENSITIVITY FREQUENCY TRANSFORMER ENCLOSURE
MODEL LOUDSPEAKER WEIGHT RESPONSE TAPS @ 70.7V DIMENSIONS VOLUME WEIGHT
M1000 8" (203mm) 10oz. 92dB
150Hz - 6kHz
(±3dB)
.25, .5, 1, 11
9
⁄16"L x 11
9
⁄16"W x 5
1
⁄2"H 734 Cubic in. 9lbs.
Dual Cone (260g)
1W/1M
120Hz - 6.5kHz
(±5dB)
2, 4 (294 x 294 x 140mm) (3.4kg.)
Need help?
General
