EasyManuals Logo
Home>Audio Technica>Microphone system>2000 Series

Audio Technica 2000 Series Installation And Operating Guide

Audio Technica 2000 Series
62 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #10 background imageLoading...
Page #10 background image
10
E
N
For future reference, please record your system information here.
Receiver ATW-R2100 S/N
Serial Number appears on the label on the back of the receiver.
UniPak™ Body-Pack Transmitter ATW-T210 S/N
Serial Number appears on the label on the back of the transmitter.
Handheld Dynamic Microphone Transmitter ATW-T220 S/N
Serial Number appears on the label on the interior of the transmitter.
1. Use only fresh alkaline batteries. Do not use “general purpose” (carbon-zinc)
batteries.
2. Position the receiver so that it has the fewest possible obstructions between it
and the normal location of the transmitter. Line-of-sight is best.
3. The transmitter and the receiver should be as close together as
conveniently possible, but no closer than three feet (1 m).
4. The receiver antennas should be in the open and away from any metal. If
mounted in a rack, have the unit on top, or use an ATW-RA1 kit to front-
mount the antennas.
5. The transmitter and receiver must be set to the same channel number.
6. A receiver cannot receive signals from two transmitters at the same time.
7. If the AF Level control of the receiver is set too high, it may over-drive the ``
input of the mixer or clip the output of the receiver, causing distortion.
Conversely, if the receiver output is set too low, the overall signal-to-noise
ratio of the system may be reduced. Please see Setting Levels section,
pages 7.
8. You need to change channels when a strong interference signal is
received (a strong RF signal is shown with the transmitter off).
9. In the UniPak transmitter, the microphone level trim or instrument level trim
input control not in use should be set to minimum.
10. Turn the transmitter off when not in use. Remove the battery if the
transmitter is not to be used for a period of time.
Ten Tips to Obtain the Best Results
2000 Series Frequency Channel Plan
Channel Frequency - MHz TV Channel
1 848.500 Co-ordinated
2 854.900 Shared
3 855.275 Shared
4 858.200 Shared
5 858.650 Shared
6 860.400 Shared
7 863.025 Licence Exempt
8 863.325 Licence Exempt
9 864.300 Licence Exempt
10 864.950 Licence Exempt
Note: All frequencies selected to avoid standard analog TV carrier interference.
For licencing information in the UK, please contact: JFMG Ltd, 33-34 Alfred Place, London, WC1E 7DP,
Tel: 0207 299 8660; Fax: 0207 299 8661; E-mail: info@jfmg.co.uk; Web: www.jfmg.co.uk
For other countries in the EU/Europe, please contact your local dealer or radio authority.
OM 2000 Serie (Nov.08).qxd:FINAL OM2000 All.qxd 26/11/08 16:00 Page 10

Other manuals for Audio Technica 2000 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Audio Technica 2000 Series and is the answer not in the manual?

Audio Technica 2000 Series Specifications

General IconGeneral
BrandAudio Technica
Model2000 Series
CategoryMicrophone system
LanguageEnglish

Related product manuals