To configure general media parameters:
1. Open the General Media Settings page (Configuration tab > VoIP menu > Media
submenu > General Media Settings).
Figure 16-9: Coder Attribute Configuration in General Media Settings Page
2. Configure the parameters as required, and then click Submit.
3. To save the changes to flash memory, see 'Saving Configuration' on page 624.
16.7 Configuring Media Realms
The Media Realm Table page allows you to define a pool of up to 64 SIP media interfaces,
termed Media Realms. Media Realms allow you to divide a Media-type interface, which is
configured in the Multiple Interface table, into several realms, where each realm is
specified by a UDP port range. You can also define the maximum number of sessions per
Media Realm. Once configured, Media Realms can be assigned to IP Groups (see
'Configuring IP Groups' on page 210) or SRDs (see 'Configuring SRD Table' on page 205).
Once you have configured a Media Realm, you can configure it with the following:
Quality of Experience parameters for reporting to AudioCodes SEM server used for
monitoring the quality of calls (see Configuring Quality of Experience Parameters per
Media Realm on page
176)
Bandwidth management (see 'Configuring Bandwidth Management per Media Realm'
on page
179)
Notes:
• If different Media Realms are assigned to an IP Group and to an SRD,
the IP Group’s Media Realm takes precedence.
• For this setting to take effect, a device reset is required.
• The Media Realm table can also be configured using the table ini file
parameter, CpMediaRealm or CLI command, configure voip/media
realm.
To Next Page
Loading...
Need help?
General
