35/83
IT EN FR DE ES
The cooling unit is supplied already loaded with the coolant; however, if needed, carry out loading procedures by following the instructions
provided and by complying with the type and amount of coolant.
THE USE OF ANOTHER TYPE OF COOLANT INSTEAD OF THAT ENVISAGED IS NOT ALLOWED.
If in doubt, contact the AUTOCLIMA servicing department.
Close or open the connections of the cooling circuit, using two spanners to balance the tightening torque.
Avoid contact with synthetic oils. Wash carefully after contact.
Dispose of the packing materials as required by the standards in force, separating them if a separate waste disposal system is available.
When working near to the coils (evaporator and/or condenser) pay attention not to cut yourself on the edges of the ns.
During operations that implicate the handling of cooling uid, remember that:
- when it is close to a source of heat it produces an unpleasant smelling gas which irritates the eyes and the respiratory system
- a circuit containing cooling uid must never be heated with a ame, because it is easily inammable
- in its liquid state, cooling uid evaporates when it comes into contact with the atmosphere and freezes everything it comes into contact with.
If it freezes:
- plunge the frozen part immediately into COLD water. If there is no water available, gently wrap the frozen part in a clean cloth.
If the cooling uid has come into contact with the eyes, rinse them thoroughly with clean water and see a doctor.
The oil contained in the system is inammable.
BEFORE OPERATING ON THE COOLING CIRCUIT WITH FLAMES, ENSURE THAT THERE ARE NO TRACES OF COOLANT LEFT INSIDE
THE SYSTEM.
Perform the recovery and open the system; wait for the remaining coolant to come out.
ATTENTION: SOME PARTS OF THE SYSTEM MAY CONTAIN OIL THAT CAN IGNITE EVEN IN THE ABSENCE OF COOLANT.
To Next Page
Loading...
Need help?
General
