4.3. Startup & shutdown
Notes:
Startup & shutdown operation can only be conducted in the main interface.
When it displays with half screen o or full screen o, click any key for re-
turning to ON/OFF main interface.
When the unit is started under the control of wire controller, if using the
emergency switch to shut down, the wire controller will display as follows:
Operations are the same as under ON/OFF main interface
17
4.Use and Operation Instruction
12
4.3. Startup & shutdown
Keep long press of " "for 0.5 s
to enter ON/OFF interface
When there is no operation
within 15 minutes, it will
display with full screen off
When the unit is started under the control of wire controller, if using the emergency switch to
shut down, the wire controller will display as follows:
Operations are the same as under ON/OFF main interface.
4.4. Mode switch
Under the main interface, Short press" "to switch the unit among heating " ", cooling " "
and automatic mode " ".
When there is no operation
within 1 minute, it will display
with half screen off
Notes:
Startup & shutdown operation can only be conducted in the main interface.
When it displays with half screen off or full screen off, click any key for returning to ON/OFF
main interface.
13
4.Use and Operation Instruction
Notes: Under the temperature setting interface, if short press " ", the system will return to
the main interface without any changes saved; If there is no operation for 5 s or short press
" ", the current mode will be saved, and return to the main interface.
Short press" " for to switch the
mode circularly, after no operation
for 2s, the current mode will be saved.
Cooling mode
Automatic mode
2). When the unit is under the defrosting state, the defrosting symbol is on,with the display
interface as follows:
Notes:
1).After completing the defrosting, the unit will be automatically switched to the heating/
automatic mode (keeping consistent with the mode before defrosting).
During the defrosting, mode switch is available. And when switching the mode, the unit won t
work under a new mode until defrosting is completed.
Heating mode
Operation descriptions:
1). Mode switch operation can only be conducted in the main interface.
4.5. Temperature setting
Press " " or " " for increasing
or decreasing target temperature.
Defrosting state
To Next Page
Loading...
Need help?
General
