Glider Board
Glider Board
Instructions
Box Includes:
1 Glider Board
1 Push the safety cover away from the tabs.
2a To Raise: Squeeze tabs on right and
left side of Glider Board and pull up.
2b To Lower: Squeeze tabs on right and
left side of Glider Board and push down.
3 Pull the safety cover back over the tabs.
WARNING: Always secure seat recline
strap to recline clamp before using
the Glider Board.
To Adjust Glider Board Angle:
NOTE: GLIDER BOARD MUST BE PARALLEL TO THE GROUND BEFORE USE.
Depending on your stroller model, you may need to adjust the angle.
4 Press ratchet lock tab
and slide ratchet strap
through opening.
5 Push ratchet strap through
until snug. Repeat on
other side.
2 Slide ratchet straps between the lower
support bar and the brake rods.
3 Place attachment brackets onto lower
support bar.
1 Insert wheel axle into the hole on the
underside of the Glider Board. The
wheel is secure when you hear it click.
Repeat on other side.
WARNING: Always ensure the safety covers are covering the adjustment tabs prior to use.
To Next Page
Need help?
General
