Coffee flows too quickly, little and very light crema
Coffee powder has been
ground too coarsely
Boiler temperature set too low
► Set a finer grinding
degree.
► Increase the boiler
temperature.
Coffee / Water is not hot
If the temperature and pressure
are still low, the preheating time
has not yet ended
Boiler temperature set too low
The machine is calcified
► Wait until the operating
temperature is reached.
► Increase the boiler
temperature.
► Descale the machine
There is no or too little steam
If the temperature and pressure
are still low, the preheating
time has not yet ended
When it reaches operating
temperature, the steam pipe
may be clogged
► Wait until the operating
temperature is reached.
► Close the steam valve,
unscrew the steam nozzle
and clean or replace it.
The display shows an error code
F3 Not enough water in the
tank or the water tank is
not correct.
E1 Temperature
sensor fault
E2 The drawing time is longer
than 2 minutes
E3 The pump was active and
pumped for more than
15 minutes or the
solenoid valve for filling
the boiler is defective
24 / 32
Bellezza | Espresso machines
If something does not work
► Fill the water tank and check
the correct position.
► Do not operate the machine
below 0 ° C ambient
temperature.
► Please contact your specialist
dealer.
► Stop dispensing: To do this,
move the dispensing lever
down.
► Switch the on / off switch off
and on again.
► If the fault persists, please
contact your specialist dealer.
To Next Page
Loading...
Need help?
General
