303021213752_21x14cm_54138,54173/SPA快速操作14步骤说明书插页(欧规)_英
Congratulations on the purchase of your new Lay-Z-Spa™. Before
operating the Lay-Z-Spa™ be sure to follow these 14 steps.
Damage resulting from misuse is not covered by the
manufacturer's warranty.
™
1
The Comfortable, Affordable, Go-Anywhere Spa!
™
303021213752
1
The Lay-Z-Spa™ should not
be set up or left out in
temperatures lower than
4˚C (40˚F).
Fill the water level between
maximum and minimum
printed on the SPA wall.
Water
Level
MAX
MIN
3
Remove Stopper Caps
Ensure water is circulating between
the Spa and the Pump and that the
Stopper Caps have been
removed.
4
Check to ensure the Spa and
adapters are not leaking.
6
If the pump is not heating properly,
please press the thermal cut-out
manual “Reset” button
on the pump.
9
RESET
Hibernate Function:
After 72 hours of operation (except timer
function), the pump will hibernate and “END”
will be displayed on the LED. When the
pump is hibernating both the rapid heating
and water filtration functions are disabled.
To re-active the pump simply press any
button on the control panel.
11
The PRCD plug must be tested
before each use to avoid risk of
electric shock. Do not use the
pump if this test fails.
2
10
All Spas require the use of
chemicals in order to keep
the water clear and safe.
Change the Filter Cartridges
regularly.
8
Clean and maintain the Filter
Cartridge regularly.
7
Be sure to set your desired
temperature.
5
RESET
TEST
We recommend you take a shower
before using your Lay-Z-Spa, as
cosmetic products, lotions, and other
residues on the skin can quickly
degrade water quality.
13
IMPORTANT NOTICE:
This unit will automatically lock
after 5 minutes of inactivity.
To unlock simply place a finger
over function button
for 3 seconds.
12
14
To Next Page
Need help?
General