Shenzhen BIGTREE technology co., LTD.
BIG TREE TECH
Product Introduction
BigTree Technology Co., Ltd. developed this high performance and customizable 3D
printer controller board to provide a direct replacement for the Ender 3 which has more
options.
Main Features
1) The board is controlled by a STMicroelectronics ARM Cortex M3 32-bit
STM32F103RCT6 MCU. This chip has a Maximum Clock Frequency of 72 MHZ.
2) Supports 2.8 inch, 3.5 inch color touch screen and original Ender3 printer
LCD12864 screen.
3) Supports open source firmware Marlin2.0. This means it is convenient for users
to customize their firmware and develop it. The firmware is upgraded with a SD
card, which is very convenient and efficient!
4) Supported drivers are TMC 5160, TMC 2208, TMC 2209, LV8729, ST820, A4988,
etc.
5) Dedicated ports for BL Touch, Stallguard, UART and SPI. Supports TMC2130 SPI,
TMC5160 SPI, TMC2208 & TMC2209 UART.
6) High voltage input means heated bed current draw can be reduced to
1/4,without power loss.
7) Supports functions such as BL touch, Stallguard printing after power failure and
power off after print finished.
8) The layout of the PCB is optimized for heat dissipation.
Board specifications
1) Size: 100x70.25mm
2) Input voltage: 12V-24V DC
3) Max. allowable total power usage: 180W@12V, 360W@24V
2
To Next Page
Loading...
Need help?
General
