13
DANSK
ENGLISH ENGLISHFRANÇAISITALIANO
NEDERLANDS
SVENSKAESPAÑOL
PORTUGUÊS
Radio mode
Switching to radio mode
If you are in SD, CD changer or AUX-IN
mode,
press the BND/TS button 4
or
press the SRC button ? repeatedly
until the display shows "TUNER".
Selecting the waveband/memory
bank
This device can be used to receive stations
in the FM and AM frequency bands. Three
memory banks (FM1, FM2 and FMT) are
available for the FM waveband and two
memory banks (AM and AMT) for the AM
waveband.
Five stations can be stored in each memory
bank.
To switch between the memory banks FM1,
FM2 and FMT or AM and AMT,
briefl y press the BND/TS button 4.
Tuning into a station
There are various ways of tuning into a sta-
tion.
Automatic station seek tuning
Press the
or button 5.
The radio tunes into the next receivable sta-
tion.
Tuning into stations manually
You can also tune into stations manually.
Press the
or button 5.
쏅
쏅
쏅
쏅
쏅
Setting the sensitivity of station
seek tuning
You can choose whether the radio should
only tune into stations providing good recep-
tion or whether it can also tune into those
with a weak reception.
Press the M•OK button >.
The display shows "MENU".
Press the
or button 5 repeatedly
until "SENS" and the currently set value
appears on the display.
"SENS HI6" means that the tuner is set to
the highest sensitivity setting. "SENS LO1"
means it is set to the lowest sensitivity set-
ting.
Press the M•OK button > to change the
set value.
Set the sensitivity level that you want us-
ing the
buttons 5.
When you have fi nished making your chang-
es,
press the M•OK button >.
To exit the menu,
press the ESC button 6 or wait approx.
8 seconds.
Note:
You can adjust different sensitivities for
FM and AM.
쏅
쏅
쏅
쏅
쏅
쏅
To Next Page
Loading...
Need help?
General
