BMC G2S BPAP Series Quick Operation Manual

G2S BPAP Series Quick Operation Manual V2.0
2 / 2
B. From the Main Interface shown above, press and hold the Ramp Button for three
seconds. The screen displays the Initial Setup Interface, as shown in the figure below.
C. Press the Knob to access the Setup Interface, as shown in the figure below.
D. Press and turn the Knob to adjust an option.
E. Press the Knob to confirm your adjustment to the option.
F. The cursor switches among the options as you turn the Knob . Refer to steps C-E to adjust
other options. When the cursor is on the Home option, as shown in the figure below, press the
Knob to exit the Setup Interface.
4. Starting Treatment
After you finish adjusting device settings and return to the Main Interface, press the Knob to
start treatment.

BMC G2S BPAP Series Specifications

General

IPAP	4-30 cmH2O
EPAP	4-25 cmH2O
Pressure Range	4-30 cmH2O
Rise Time	1-6 levels
Operating Voltage	100-240 V AC, 50/60 Hz
Heated Humidifier	Optional
Data Storage	SD Card
Therapy Mode	S, T
Alarms	Power failure, High pressure, Low pressure, Apnea
Device Type	BPAP (Bi-level Positive Airway Pressure)
Automatic Altitude Adjustment	Automatic