Controls
101
Reference At a glanceDriving tipsCommunications NavigationEntertainmentMobility
3. Select the menu item and press the control-
ler:
> "Night Vision off":
Deactivate BMW Night Vision.
> "Zoom":
At higher speeds, the image is zoomed
in.
> "Curve mode":
Depending on the steering angle and
other parameters, the image sections
follow the course of the road to some
degree.
> "Full screen":
The image is shown on the entire Con-
trol Display.
> "Contrast":
The contrast of the screen can be
adjusted.
> "Brightness":
The brightness of the screen can be
adjusted.
"Curve mode" can only be activated with
the "Zoom" function switched on. With
"Full screen" activated, "Curve mode" and
"Zoom" cannot be selected.<
The settings are stored for the remote control
currently in use.
To exit the menu:
The image will automatically disappear after
approx. 5 seconds.
Cleaning camera
The function of the camera may be affected by
heavy rain and fog, dirt, snow or ice on the lens.
When this occurs, the displayed image on the
Control Display may become gray.
To minimize icing, the camera lens is automati-
cally heated. However, it may be necessary to
clean the camera lens manually under severe
weather conditions. When doing so, cautiously
remove any debris, ice or snow. To avoid dam-
age to the lens, do not use sharp or abrasive
instruments to clean ice, snow, or dirt off the
lens.
When the windshield is cleaned with the head-
lamps on, the camera lens area is automatically
sprayed as well. Refer to page 66.
Online Edition for Part no. 01 41 0 013 312 - © 02/07 BMW AG
To Next Page
Loading...
Need help?
General
