Roadside parking light
Concept
The vehicle can be illuminated on one side.
Switching on
With radio-ready state switched off, press the
lever either up or down past the resistance point
for approx. 2 seconds.
Switching off
Briefly press the lever to the resistance point in
the opposite direction.
Welcome lights and
headlight courtesy delay
feature
Welcome lights
General information
Depending on the vehicle equipment and the
ambient brightness, individual light functions may
be switched on briefly when the vehicle is un‐
locked.
Activating/deactivating
Position of switch: ,
Via iDrive:
1.
"Settings"
2. "Lighting"
3. "Welcome lights"
Settings are stored for the profile currently used.
Headlight courtesy delay feature
General information
The low beams stay lit for a short while if the
headlight flasher is switched on after the radio-
ready state is switched off.
Setting the duration
Via iDrive:
1.
"Settings"
2. "Lighting"
3. "Pathway lighting:"
4. Set length of time.
The setting is stored for the driver profile cur‐
rently used.
Automatic headlight
control
Concept
The low beams are switched on and off automat‐
ically depending on the ambient brightness, for
instance in tunnels, in twilight or if there is pre‐
cipitation.
General information
A blue sky with the sun low on the horizon can
cause the lights to be switched on.
When emerging from a tunnel during the day, the
low beams are not switched off immediately but
instead only after approx. 2 minutes.
The low beams always stay on when the fog light
is switched on.
Activating
Position of switch:
Seite 129
Lights
CONTROLS
129
Online Edition for Part no. 01402896102 - X/18