Specifications subject to change without notice.
© 2009 Bogen Communications, Inc.
All rights reserved. 54-5810-05B 1007
BPA60
Power Amplifier
Installation & Use Manual
Rated Output Power: 60 watts
Total Harmonic Distortion: Less than 2% from 50 Hz to 15 kHz
Frequency Response: -2 dB, 20 Hz to 20 kHz
Input Sensitivity: High-impedance, 300mV; low-impedance balanced (with optional
transformer), 75mV
Hum and Noise: 85 dB below rated output
Output Loads: 8-ohm/25V, 16-ohm, 25V CT, 70V
Output Regulation: Better than 2 dB from no load to full load
Input Impedances: High-impedance, 50k ohms unbalanced; low-impedance, 600 ohms,
balanced (with optional transformer)
Lo-cut Filter: -10 dB at 100 Hz (switch-selectable)
Controls and Indicators:
Front Panel
— Illuminated on/off power switch
Rear Panel
— Input level control, circuit breaker reset, lo-cut filter switch
Power Consumption: 120V AC, 60 Hz, 180W at full rated output
Thermal Emissions (full power): 204.9 BTU/hr.
Overload Protection: Transient protection diodes, electrical circuit breaker,
thermostat
Auxiliary Receptacle (not switched): Three-wire grounded*, 300W maximum, 2.5A (internally fused)
Dimensions: 15-1/4"W x 3-1/2"H x 8"D
Finish: Black
Weight: 19 lbs.
Accessories: Model TL600, 600-ohm line-matching transformer;
Model TL100, 1:1 ratio transformer
Model RPK53 rack panel brackets
*This receptacle will be grounded only if the power amplifier has been grounded properly.
Technical
Specifications
To Next Page
Need help?
General
