18
en | How the system reports events Control Panels
2019.06 | 07 | F.01U.307.371 Bosch Security Systems B.V.
6 How the system reports events
Your security system makes repeated attempts to send reports to your
security company. In the event your security system fails to
communicate, the keypad sounds the trouble tone and the keypad
shows a communication failed message. Notify your security company
of the communications failure.
If your telephone, internet, or cellular service is interrupted, your
security system cannot send reports to the security company unless an
alternate means of transmitting the reports exists.
For telephone communication, your security company can program your
security system to automatically disconnect the telephones when
sending reports to the security company. Once the report finishes, the
security system returns the telephones to normal operation (check with
your security company).
Consult with your installer to determine if your security system is
configured with a communicator delay. A communicator delay aborts
reports to your security company if the control panel is disarmed within
30 to 45 seconds after a burglary alarm is triggered. Note that fire-type
alarms are always reported without a delay.
Consult with your installer to determine if your security system is
configured with a cancel feature. If you silence a non-fire alarm before
the alarm sound timer expires, your security systems sends a cancel
report to your security company.
To Next Page
Loading...
Need help?
General
