English - 1
1
Clamp
2
On/Off switch
3
Lock-on button for On/Off switch
4 Dust box (micro filtersystem)
5 Sanding plate
6 Sanding sheet*
7 Holder
8 Outlet piece
9 Latching lever
10 Filter element (micro filtersystem)
11 Extraction adapter*
12 Perforating tool*
* Not all of the accessories illustrated or described are
included as standard delivery.
Measured values determined according to
EN 50 144.
Typically the A-weighted sound pressure level of
the product is 83 dB (A).
The noise level when working can exceed
85 dB (A).
Wear hearing protection!
The typically weighted acceleration is 6 m/s
2
.
The machine is intended for the dry sanding of
surfaces of wood, plastic and filler as well as for
painter surfaces.
Working safely with this ma-
chine is possible only when the
operating and safety information
are read completely and the in-
structions contained therein are
strictly followed. In addition, the
general safety notes in the enclosed booklet
must be observed.
■ Wear safety goggles.
■ The dust that is produced while working can be
detrimental to health, inflammable or explo-
sive. Suitable safety measures are required.
Examples: Some dusts are regarded as carci-
nogenic. Use suitable dust/chip extraction and
wear a dust respirator.
Dust from light alloys can burn or explode. Al-
ways keep the workplace clean, as blends of
materials are particularly dangerous.
■ If the mains cable is damaged or cut through
while working, do not touch the cable but im-
mediately pull the mains plug. Never use the
machine with a damaged cable.
■ Connect machines that are used in the open
via a residual current device (RCD) with an ac-
tuating current of 30 mA maximum. Do not op-
erate the machine in rain or moisture.
■ The machine can be used only for dry sanding.
■ Insert the mains plug only when the machine is
switched off.
■ Always direct the cable to the rear away from
the machine.
■ Do not work with materials containing asbes-
tos.
■ Secure the workpiece. A workpiece clamped
with clamping devices or in a vice is held more
secure than by hand.
Tool Specifications
Orbital sander PSS 150 A-C PSS 180 A-C
Order number 0 603 366 2.. 0 603 366 1..
Rated input [W] 150 180
Orbit frequency [opm] 24 000 24 000
No-load speed [rpm] 12 000 12 000
Orbit diameter [mm] 1.8 1.8
Sanding sheet: [mm] 93 x 230 93 x 230
Weight (without accessories), approx. [kg] 1.5 1.5
Protection class / II / II
Please observe the order number of your machine. The trade names of the individual machines may vary.
Machine Elements
Noise/Vibration Information
Intended Use
For Your Safety
7 • 2 609 932 212 • TMS • 18.03.03
To Next Page
Loading...
Need help?
General
