Bose S1 Pro Repair Return Setup Instructions
When your product was repaired, it was reset to a Factory Default state.
Your S1 Pro will not turn on/operate until you perform the below steps.
Connecting Power
1. Make sure the power switch is in Standby.
2. Plug the power cord into the connector on the S1 Pro.
3. Plug the other end of the power cord into a live electrical outlet.
4. Allow the system to charge the battery until it is fully charged.
Charging the Battery
Anytime your S1 Pro is plugged into AC power and the system is not in use, the battery is charging.
Quick Charge
Though the battery will always charge while your S1 Pro is connected to AC power, Quick Charge
enables you to charge your battery more quickly. To enable Quick Charge, turn the power switch
to Quick Charge ( ) when not in use.
Battery Life Indicator
The current state of the battery life is shown by the power LED, which will flash when the unit is
powered on. You can also check the battery life by double-clicking the Bluetooth® Pair button,
which will cause the power LED to flash. See the following table for charge indicators:
× 2
× 4 >75%
× 3 50%-75%
× 2 25%-49%
× 1 10%-24%
× 1 <10%
Note: A sticker depicting the above table is included with your S1 Pro. For easy reference, it is
recommended that you apply this sticker to the bottom plate of your S1 Pro.
Date Issued: 2/4/2022
Bose Corporation, 100 The Mountain, Framingham, Ma. 01701-9168
Service documentation available Online at http://serviceops.bose.com
787930-IS1 rev. 00
To Next Page
Need help?
General
