Bose SL2 User Manual

8
YOUR SL2 WIRELESS SURROUND LINK
E
ng
li
s
h
D
eu
t
sc
h
F
ran
ç
a
i
s
D
ans
k
E
spa
ñ
o
l
It
a
li
ano
S
vens
k
a
N
e
d
er
l
an
d
s
To adapt the surround speaker cable for Jewel Cube
®
speakers
Follow these steps before you connect the provided surround speaker cable to your Jewel
Cube
®
speakers.
1. Loosen the screws on the Jewel Cube
®
adapter so you can insert the two-wire ends into
its terminals.
• Insert the plain wire (–) into the black terminal.
• Insert the marked wire (+) into the red terminal.
2. Tighten the screws (Figure 5).
Figure 5
Attaching the
Jewel Cube
®
adapter
3. Using this cable with the adapters attached, follow the steps in “To make the receiver
connections” on page 7. Be sure to match each adapter to the proper speaker, right or
left.
Setting the transmitter for your system
The SL2 Wireless Surround Link is set for optimal use with LIFESTYLE
®
system speakers.
There is no need to change the switch setting on the bottom of the transmitter.
Important Note: Running the ADAPTiQ
®
audio calibration system, which is provided with
your LIFESTYLE
®
system, helps ensure the most accurate sound from your system. Be sure
to use it after the SL2 is connected and your surround speakers are in final position.
If your speakers are part of an Acoustimass
®
speaker system, you need to set the switch on
the bottom of the SL2 transmitter to Other (
Figure 6).
Figure 6
Speaker switch
Black terminal
Rese
t
FCC IC
Bottom of the
SL2 transmitter
Switch

Bose SL2 Specifications

General

Brand	Bose
Model	SL2
Category	Receiver
Language	English