Brother BAS-415 User Manual

liJ List of error messages
( BAS-411 )
Refer to the table below if an error message is displayed.
By pressing the <END> key, the message will disappear and the display will return to the previous menu.
<List of error messages 1 >
Message when power is
Cause
Solution
turned on
Keyboard ROM NG.
PROM version of key board does
Change PROM version of key
not match PROM version of PCB.
board to matching PROM version
of PCB. Contact your dealer.
N Bar stop
ERR
Pulley is not in proper position.
Turn
pulley till needle bar is in
proper position.
Missed X
ORG. PT
Damaged circuit board, sensor
Contact your dealer.
Missed
Y
-ORG.PT
defective, cable defective, pulse
-
motor defective, blown fuse.
Over travel
1.
X-Y carriages movement
Turn
power off. Move carriages X
exceeds maximum area.
and
Y to center of area manually,
then turn power on again.
If same error message is displayed
again, turn power off, then on
again while pressing
<EMERGENCY> key.
(Clearing backup memory.)
2. Overtravel sensor is in incorrect Contact your dealer.
position
or defective.
3. XY home position sensor is in
incorrect position
or defective.
4. Damaged circuit board.
Memory Clear
Back-up data in the memory Press key according to message.
disappears.
Message in entry mode Cause Solution
No file
Inputted data has something
Check file name of data and re-
wrong.
enter.
Data
ERR.
Check where data was made, then
contact your dealer.
Disk
ERR.
1.
Data is input without inserting
Insert floppy disk in proper
floppy disk.
position and re-enter.
2.
While reading data, floppy disk
Do
not remove floppy disk from
is removed when machine runs
FDD during sewing in this mode.
in sewing mode.
3.
Damaged circuit board,
Contact your dealer.
defective cable, defective
FDD.
-122-
From the library of: Superior Sewing Machine & Supply LLC

Brother BAS-415 Specifications

General

Brand	Brother
Model	BAS-415
Category	PDA
Language	English