You must follow steps
1
to
5
to complete the setup.
Quick Setup Guide
Read the Product Safety Guide first, then read this guide for the correct installation procedure.
Keep this guide next to your machine for quick reference.
In this guide, the illustrations of the DCP-T420W are used unless otherwise specified.
Remove the protective tape and the film covering the machine.
1
Unpack the machine and check the components
DCP-T220 / DCP-T226
DCP-T420W / DCP-T425W
DCP-T426W / DCP-T428W
NOTE
• Save all packing materials and the box in case you must ship your
machine.
• We recommend using a USB 2.0 cable (Type A/B) that is no more than
2 meters long.
2
Fill the ink tanks with inbox ink
IMPORTANT
Check the ink bottle model name on the
label. Using the incorrect ink may cause
damage to the machine.
Open the ink tank cover a, remove the cap
b, and place it on the back of the cover c.
Remove the film and tighten the cap firmly.
Remove the nozzle cap and insert the bottle nozzle firmly into the ink tank so
that the ink does not spill.
The bottle is self-standing and the ink fills automatically until the bottle is empty.
To fill the ink tank faster, squeeze the bottle on both sides.
When finished, remove the bottle,
pointing the nozzle upward so the ink
does not spill.
Replace the ink tank cap. Repeat
step
2
for the other ink tanks, and
then close the ink tank cover.
BTD60BK
BT5009CMY
1
2
3
CHN-ENG
Version A
3
Load plain A4 paper in the paper tray
Fan the paper well.
Operation Videos
www.95105369.com
Installation
& Using
Videos
Inbox Ink Bottles*4
To Next Page
Need help?
General
Weight and Dimensions
