7. Wireless Controller LC-1 Set
This is a remote control device to control cameras from distance
without cord connections. The LC-1 set consists of a trans-
mitter and a receiver and the receiver is attached to the F-1
which is to be equipped with the Motor Drive MF or Power
Winder F.
8. Remote Switch 60 MF (for Motor Drive MF)
This equipment with 60cm-long cord is inserted in the remote
control jack and used when at a distance away from the camera.
9. Extension Cord E1000
This 10m-long cord is used by inserting one end of it to the
remote control jack and the other end to the Remote Control
Switch 60 MF, Remote Switch 60, or Remote Switch 3. It is
also possible to connect it to the Interval Timer L.
10. Interval Timer L (for Motor Drive MF)
This timer is used directly in connecting it to the remote control
jack. The shooting time is controlled at 3.5 frames per second
and at nine other speeds between one frame every 0.5 second
and 180 seconds.
11. Film Loader 250
The Film Loader 250 is a film winding device used to load bulk
film into the Film Magazine 250 for the Film Chamber 250.
12. Film Magazine 250
The Film Magazine 250 is for the Film Chamber 250. It can hold
a maximum of 250 exposures.
13. Time Lapse Programmer
The Time Lapse Programmer, composed of the A Unit and B
Unit, is an electrical photography system employing the F-1
equipped with the Motor Drive MF. It affords unmanned
photography for interval motion and work sampling shooting.
The A Unit functions to control the length of filming for the
release of the shutter for the F-1 at specified intervals, while the
B Unit controls the time periods the A Unit functions in.
Free Download at http://www.joe
To Next Page
Loading...
Need help?
General
