12
④ Press the MODE key to
have number increase. To
move flash to next digit, press
the TARE key.
⑤ Press ZERO key to set up
HIGH limit. The display shows
"0.0" and you can change
these numbers by pressing
MODE key. If you want to move
to next digit you can go by
pressing TARE key.
⑥ If you set up HIGH limit you
can go out by pressing ZERO
key, and you can see "ENd"
message shortly and "WL
on" message on the display.
⑦ If you set up HIGH limit and LOW limit incorrectly, "Err" will be shown on the display.
Then you may need to set it up again. For example, LOW LIMIT=69.9 kg and HIGH
LIMIT=79.9 kg this is incorrect setting because HIGH limit is lower than the LOW limit.
When HIGH and LOW limit are set as the same or above maximum capacity it still shows "Err" message.
⑧ If you want to go back to the
simple weighing mode just
press MODE key twice.
⑨ Suppose that the HIGH limit
and LOW limit are set up as
79.9kg and 69.9kg respectively.
If the weight loaded is 2kg
between HIGH and LOW limit
the display shows "OK" and the
scale continues to beep slowly.
If the weight loaded is above
79.9kg, HIGH limit, the scale
continues to beep rapidly.
To Next Page
Loading...
Need help?
General
