EN-32
Use the procedure below to configure settings.
1.
Press FUNCTION.
This displays the [FUNCTION] screen.
2.
Use the U and I buttons to select a setting item.
• To go back to the previous screen, press the EXIT button.
3.
Rotate the dial to change the setting.
• After you rotate the dial once to select an option, you also will be able to change the selection using the – and + buttons.
• To go back to the previous screen, press the BACK button.
4.
Press FUNCTION to exit the setting screen.
Configuring Function Settings
Configuring Settings
Setting Item List
Function Name Description Display Name Setting Options
Transpose Raises or lowers the overall pitch in semitone steps. You
can use this feature to raise or lower the key of the
keyboard to make it easier to play a piece written in a
difficult key, or to adjust to a key that better matches a
vocalist, another musical instrument, etc.
Transpose –12 to 0 to +12
Reverb Specifies the type of reverb to be applied. Reverb Off, Room 1, Room 2,
Room 3, Room 4, Hall 1,
Hall 2, Hall 3, Hall 4,
Stadium 1, Stadium 2
Pedal Assigns a damper function to a pedal. The pedal can be
used to sustain notes and to apply other effects during
performances.
Pedal Pedal Sustain, Sostenuto,
Soft, Start/Stop
Intro/Ending Assigns an intro that sounds when a rhythm starts or an
ending when the rhythm is stopped.
Intro/Ending Off, On
Chord Mode Specifies the chord fingering mode. Chord Mode CASIO Chord, Fingered 1,
Fingered 2, Fingered on
Bass, Fingered Assist, Full
Range Chord
Rhythm volume Adjusts the rhythm volume level. Rhythm Volume 0 to 127
Song volume Adjusts the song volume level. Song Volume 0 to 127
Dance Music
volume level
Adjusts the dance music volume level. Dance Volume 0 to 127
Tuning Fine tunes the overall pitch of the Digital Keyboard by
changing the frequency of A4 in 0.1Hz units.
Tuning 415.5 to 440.0 to 465.9
MIDI Out Channel Specifies the channel to output MIDI messages. MIDI Out Ch 1 to 16
MIDI Out Octave
Shift
Specifies, in octave units, the note message key number
for MIDI Out.
MIDIOutOctShift –3 to 0 to +3
MIDI Out Velocity Specifies the velocity of the note on message for MIDI
Out.
MIDIOutVelocity Off, 1 to 127
To Next Page
Loading...
Need help?
General
Weight and Dimensions
