English
Playing Built-in Songs
E-19
2.
When song playback reaches the measure you
want to specify as the start measure, press
7
.
This specifies the measure as the start measure.
3.
When playback reaches the measure you want
to select as the end measure, press
7
again.
This specifies the measure as the end measure and starts
repeat playback of the measures in the specified range.
• During repeat play you can use
bk
to pause playback,
9
to skip forward, or
8
to skip back.
4.
Pressing
7
again returns to normal playback.
Changing the song number clears the start measure and
end measure of the repeat operation.
You can use the following procedure to change the speed
(tempo) in order to slow down playback to practice difficult
passages, etc.
1.
Press
6
.
Use w (slower) and q (faster) to change the tempo
setting. Holding down either button changes the setting at
high speed.
• Pressing w and q at the same time will return the
current song to its original default tempo.
• Pressing
6
causes the tempo value to flash on the
display. While the tempo value is flashing, you can use
bq
(10-key) to change it. The tempo value will stop
flashing if you do not perform any operation for a short
while.
• Changing the song number will return the song to its
original default tempo.
Use the following procedure to adjust the balance between
the volume of what you play on the keyboard and song
playback volume.
1.
Press
3
(FUNCTION) a number of times until
“Song Vol” appears on the display (page E-4).
2.
Use the
bq
(10-key) [–] and [+] keys to adjust
the song volume.
Flashes
Lights
Disappears
Changing Playback Speed (Tempo)
Adjusting the Song Volume
Song Vo l
To Next Page
Loading...
Need help?
General
