EasyManuals Logo
Home>Casio>Electronic Keyboard>CTK-530

Casio CTK-530 Service Manual

Casio CTK-530
18 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #7 background imageLoading...
Page #7 background image
— 7 —
Filter Block
From DAC
To power amplifier
Name Voltage For operation of
VDD +5 V CPU, Reset IC, Sound source ROM, LED Latches
DVDD +5 V Power jack, Photocoupler
AVDD +5V DAC, Filter
LVDD +5 V LED Drivers
VCC +9 V Power amplifier, Pilot lamp
VC +9 V Power amplifier
Pin No. Terminal In/Out Function
1 Power GND In Ground (0V) source
2 Ch1 B.S. Terminal for a bootstrap capacitor
3 Ch1 OUT Out Channel 1 output
4 VCC In +9V source
5 Ch1 N.F. In Negative feedback input
6 Ch1 IN In Channel 1 input
7 D.C. Terminal for a decoupling capacitor
8 Pre GND In Ground (0V) source
9 Stand by In Power control signal input. 0 V: Off, +9 V: On
10 Ch2 IN In Channel 2 input
11 Ch2 N.F. In Negative feedback input
12 Ch2 OUT Out Channel 2 output
13 Ch2 B.S. Terminal for a bootstrap capacitor
14 NC Not used
POWER SUPPLY CIRCUIT
The power supply circuit generates six voltages as shown in the following table. VDD voltage is always
generated. The others are controlled by APO signal from the CPU.
FILTER BLOCK
Since the sound signals from the DAC are stepped waveforms, the filter block is added to smooth the
waveforms.
POWER AMPLIFIER (IC102: LA4598)
The power amplifier is a two-channel amplifier with standby switch.
The following table shows the pin function of IC102.

Other manuals for Casio CTK-530

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Casio CTK-530 and is the answer not in the manual?

Casio CTK-530 Specifications

General IconGeneral
BrandCasio
ModelCTK-530
CategoryElectronic Keyboard
LanguageEnglish

Related product manuals