E-45
4. Align the terminals on the bottom of the
DT-X400 with the power supply terminals in the
USB Cradle before inserting the DT-X400 (
).
Push the DT-X400 fully into the USB Cradle
until the mount hooks in the cradle engage the
mount holes in the DT-X400(
).
To remove the DT-X400 from the USB Cradle,
tilt the DT-X400 forward to disengage the mount
hooks from the mount holes and then lift the
DT-X400 out of the cradle.
Precautions for Use
• Even if the battery in the DT-X400 is already fully charged, charging will begin when
you set the DT-X400 in the USB cradle. It may take several minutes for the fully
charged status to be indicated.
• In high- or low-temperature environments, charging may be restricted to protect the
battery pack. At such temperatures, the level of battery charge may not reach 100%
even when the charging status LED is green and charging is completed.
• Water or other moisture on the power contacts could cause sparking or an electric
shock, and soiled contacts could block the connection and impair charging
functionality. To ensure safety, clean the power contacts by wiping them off with a
dry cloth or cotton bud after you disconnect the AC adapter.
• When disconnecting the AC adapter from the mains power outlet and DT-X400, do
so by gripping the connector and not by pulling on the cord.
USB Cradle (HA-S60IO) Specifications
1. USB specifi cations
Standard : USB 2.0 High Speed
Transmission speed : 480 Mbps (maximum)
2. Charging specifi cations
Charging method : Constant-voltage constant-current charging
Charging time : Approx. 4 hours
3. AC adapter specifi cations
Standard : AD-S50400A
Input : 100-240V AC, 50/60Hz, 0.7A
Output : 5V DC, 4A
4. Dimensions, weight
Dimensions : Approx. 102(W) × 140(D) × 131(H) mm
Weight : Approx. 370g
5. Operating environment
Operating temperature : 0°C to 40°C
Operating humidity : 10-90% RH (condensation-free)
To Next Page
Loading...
Need help?
General
