Operation Guide ID-15S
2
USING THE ALARM
The alarm sounds when the alarm time you set is
reached. You can also use the Alarm Mode selector (3)
to select the snooze alarm feature.
Setting the Alarm Time
Use the + and – buttons (6) to set the alarm time.
Pressing the + and – buttons (6) causes the alarm time
to appear in place of the date on the display.
• Holding down + or – changes the digits at high speed.
Turning the Alarm On and Off
Use the Alarm Mode selector (3) on the back of the clock to turn the alarm on and off, and to select the snooze
feature.
• The alarm time appears in place of the date on the display whenever the Alarm Mode selector (3) is set to ON
or SNZ.
• The volume of the alarm sound cycles through five levels as it sounds.
Stopping the Alarm
• When alarm is sounding, press the ALM/SNZ button (1) to stop it. When the snooze feature is turned on, the
alarm will sound again in about five minutes.
• To turn off the snooze feature, slide the Alarm Mode selector (3) to OFF.
Alarm Mode selector
OFF
Description
The alarm sounds at the preset time for one minute, and up to seven more times every
five minutes thereafter. Even if you stop the alarm by pressing the ALM/SNZ button
(1), the alarm sounds again about five minutes later.
• The indicator
flashes on the display to indicate that the snooze feature is
activated.
The alarm sounds at the preset time for one minute.
The alarm does not sound.
SNZ
ON
THERMOMETER FUNCTIONS
• A built-in sensor measures temperature and shows the measured value on the display.
• The temperature display shows “LO” for temperatures below –19.9°C (–3.8°F) and “HI” for temperatures above
49.9°C (121.8°F).
• Though temperature readings are displayed up to 0°C (32°F) and greater than 41°C (105°F), note that such
readings are actually outside the guaranteed temperature range of this clock.
Switching between Celsius and Fahrenheit
• Push the °C/°F button (5) to select either Celsius (°C) or Fahrenheit (°F).
• Switching between Celsius and Fahrenheit causes current high temperature and low temperature memory
contents to be cleared.
C/ F button (5)
Celsius ( C) Fahrenheit ( F)
C
F
High Temperature and Low Temperature Memory
• The clock remembers the highest and lowest temperature readings for the current 24-hour day. Daily high and
low values are cleared each day at midnight.
Changing the Temperature Display Screen
• Each press of the MAX/MIN button (4) cycles between screens as illustrated below.
MAX/NIN button (4) MAX/NIN button (4)
MAX/NIN button (4)
Current temperature
High temperature Low temperature
Turning On Temperature Screen Auto Cycling
• Hold down the MAX/MIN button (4) for about one second. This will turn on temperature screen auto cycling,
which causes the screen contents to cycle as illustrated below at regular intervals.
Current temperature
High temperature Low temperature
• To turn off temperature screen auto cycling, press the MAX/MIN button (4).
ALM/SNZ DEMO
MAX/MIN
ON
OFF
RESET SET
SNZ
C/ F
Press
–
to
change the
alarm time
setting.
Press
+
to
change the
alarm time
setting.
To Next Page
Loading...
Need help?
General
